Quad 4 Pace car buildup thread!

Click here to visit the donation page | View all sponsors

Pennock's Fiero Forum

General Fiero Chat - Archive

Quad 4 Pace car buildup thread! (Page 4)

T H I S I S A N A R C H I V E D T O P I C

Email This Page to Someone! | Printable Version

This topic is 4 pages long: 1 2 3 4
Previous Page | Next Page

Quad 4 Pace car buildup thread! by Fierobsessed

Started on	: 03-15-2004 02:53 AM
Replies	: 123
Last post by	: Fierobsessed on 01-07-2006 11:54 AM

Fierobsessed
Member

Posts: 4782
From: Las Vegas, NV
Registered: Dec 2001

Feedback score: N/A
Leave feedback

Total ratings: 147
Rate this member

Report this Post01-07-2006 02:29 AM

Continued...

I soldered in a new ZIF socket. I had to modify the ZIF socket so that it would fit next to the calibration section of the calpak.

I modified the cover to make it look better.

Completed unit

Since the ZIF socket added to the height of the chip, it was too tall to put the cover back on... So I modified the ECM cover.

Voila! easy chip removal! Also notice that I use AT29C256 chips. They are the best, no erasing necessary.