Here you go David. It's a PISA dash, but modified using Dakota Digital's gauges, Viper bezel and boot. If Jerry does the dash, it's best that he has something to use verse nothing.
IP: Logged
05:55 PM
May 17th, 2010
madcurl Member
Posts: 21401 From: In a Van down by the Kern River Registered: Jul 2003
You, Fieromagila, exoticse needs to get FL back on the map, especially at Daytona. I see from viewing the pics you plan on slanting/angling the pitch of the nose. What color have you decided on? Too many question to ask. I need to call you.
IP: Logged
02:27 PM
Apr 20th, 2011
madcurl Member
Posts: 21401 From: In a Van down by the Kern River Registered: Jul 2003
well we got back into work yesterday and got back to work on the car cleaning, painting and rebuilding the drivetrain. new oil pump, water pump, bearings and all new seals and gaskets. the bearings were a ready for new ones but not bad. the rear main seal was leaking in to the clutch and the clutch was fried. today I will be drpoing off the flywheel to get it redone as well as getting a few other parts. I will keep you all posted as it goes. here are some pics so far, A little better looking now I think D.
IP: Logged
07:45 AM
May 19th, 2011
whodeanie Member
Posts: 3819 From: woodstock,Ga.,USA Registered: Jan 2008
well the drive train is back in 25 now we still have a lot more work to do on it with the harness, low mount alt and a fe other details but looking way better now. D.
IP: Logged
07:24 AM
exoticse Member
Posts: 8654 From: Orlando, Fl Registered: Jun 2003
well the drivetrain is back in the car now and I hade a new top dogboun mount for it as well. now I need to get the low mount alt in place then it is a few days of clean up on the wiring. friday we got it taken apart now today we will start rerunning it. we had to fix a few things on it first some of the sensor wires were run to ground and never hooked up. the pass key was rigged in and the fuel pump someone wired in the relays from the fiero and the donor car to the same thing and it would work when it felt like it. more to come later. D.
the low mount alt and the dog bone are now finished and installed. we have about 70% of the wiring done now as well. we hope to have it back running by friday. we had to fix lots of things on the car that were not up to par. like the wiring, the 3 piece coolant hoses the shotout mounts and a few other things but it is all working out nice. I will try to get some pics of it today and post them this week. we want to get all the wires run and test start the car before we recover the harness to make sure it is all in working order. D.
IP: Logged
07:21 AM
Jun 9th, 2011
whodeanie Member
Posts: 3819 From: woodstock,Ga.,USA Registered: Jan 2008
got the motor reinstalled and running again. it looks way better than it did. we had to fix a lot of things on this one but it was worth it. now we just have to install the bat box in the front and get a new tune on the motor. D.
IP: Logged
07:34 AM
exoticse Member
Posts: 8654 From: Orlando, Fl Registered: Jun 2003