Thread re-posted

[This message has been edited by gtxbullet (edited 10-11-2009).]

You have a PM.

quote Originally posted by CarverToo: You have a PM.

Pm replied

Is that pass side tail light tinted on the inside of the lens? And what did you use to tint it? VHT Niteshades? I may be interested in that, even more so if you have a matching driver side

Another PM - I assume your talking about 2.8 engine parts?

Rob

quote Originally posted by Xerces_Blackthorne: Is that pass side tail light tinted on the inside of the lens? And what did you use to tint it? VHT Niteshades? I may be interested in that, even more so if you have a matching driver side

yes I used VHT, however it could use some Clear to even the finish out.

quote Originally posted by CarverToo: Another PM - I assume your talking about 2.8 engine parts? Rob

the parts at the bottom of the list are all 3800 Series 2 parts from a swap out that I had left over.

Added in some parts I'd be willing to trade for to the original post.

and to add. if you have a complete Fast Back set up I'll trade and add some cash if it's in really good condition and Either Bright Red or Black with sunfade or cracks.

You have a PM.

Any Getrag shift cable bracket clamps? I just need the little clamp part that bolts on top to hold the shifter cable in.

Michael

quote Originally posted by Fierology: Any Getrag shift cable bracket clamps? I just need the little clamp part that bolts on top to hold the shifter cable in. Michael

unfortunately I dont

You have a PM plus a bump.

Payment and a PM sent.

LED's Shipped

More Parts Now being posted

- COMPLETE FACXTORY SUBWOOFER SET UP (needs new speaker)

- GT Vinyl Surround with Auxilary gauges and harness (I guess you could call it a GT/Formula conversion kit)

- 13 Red Super Bright (wired for easy installation) all of them for $5.00 + shipping

- 84-87 Headlight motor and mount (no cracks, breaks, or rust)

[This message has been edited by gtxbullet (edited 08-27-2009).]

You have a PM!

quote Originally posted by mikereednv: You have a PM!

PM replied

I need an right headlight motor for an 86. Will the ones you have fit and do they work?

If so I am interested in getting some replacements for both sides.

Thanks,

Carroll

quote Originally posted by Carrolles: I need an right headlight motor for an 86. Will the ones you have fit and do they work? If so I am interested in getting some replacements for both sides. Thanks, Carroll

I only have the left side motor and assembly. as for functionality it should be fine.
the previous owner of my 1986 SE purchased it from his local salvage yard and it worked then (about 7 months ago)

How much for the headlight motor and mount assembly (to fit my 86se) shipped to 35007? Is this the one you said fits the left side?

Thanks,
Carroll

quote Originally posted by Carrolles: How much for the headlight motor and mount assembly (to fit my 86se) shipped to 35007? Is this the one you said fits the left side? Thanks, Carroll

yes it's for the left (Driver's) side. PM me you full address, because UPS online doesn't offer Ground without a full address apparently. 2-3 day would be $20, so ground will probaly be around $7-10 I would think.

PM sent

PM's Replied

pm sent

pm sent re: headlight motor assembly

PM's replied

PM sent. Or, will be in a sec.

quote Originally posted by BtotheB: PM sent. Or, will be in a sec.

PM replied (a few seconds ago ;-)

quote Originally posted by gtxbullet: PM replied (a few seconds ago ;-)

Hm, didn't get anything. Maybe send to my email?

any news on those 3 notchies i need a dark gray dash (perfect condition) and some other parts

quote Originally posted by Foxy Fiero13: any news on those 3 notchies i need a dark gray dash (perfect condition) and some other parts

after I went to look at them thoroughly all the body panel had spider cracking in areas and the interiors were rotten. only usable parts were the windows and some plastic interior parts. but they wanted me to buy the whole cars. so I just walked away.

damn i need to find a dark grey dash to swap out with mine

quote Originally posted by Foxy Fiero13: damn i need to find a dark grey dash to swap out with mine

which dash do you have? because I want the two tone version. as long as there arent any cracks.

[This message has been edited by gtxbullet (edited 09-03-2009).]

it only has a bad passenger side bottom corner its the dark grey one out of a 87gt

Bump for buyers

will make package deals if you buy more than one (like combined shipping for instance. etc.

Also to add, I'm still finding more parts.

I'm going to be adding in a complete aftermarket 3-spoke steering wheel with hub/adaptor/trim and electrical hook up, and bolts. it's black leather/pleather and the horn button looks like it's from a Ferrari or Porche. infact I think the steering wheel might actually be from a 70-80's model maybe. looks nice, but I only use stock parts on my 88's interior.
Pictures will be added once I recieve it.

I'm installing a brand new Fiero store GT wheel in my friends 54k 88 Formula and he's giving me the wheel as payment for that and helping him do upper end gaskets.

------------------
1987 Fiero Auto Base Coupe 56k Original Miles (SOLD;(
1988 FIERO Coupe "IRON DUKE" 5-Speed (the show car ;-)
1992 Firebird T-Tops V-8 24k original Florida miles(collectors car)

bump

bump, need stuff sold.

Interested in just the temp/oil gauge pod cluster. No housing or face trim. You can save those and sell it with the other trim pieces.... I live in CA 92337. I have paypal


pm sent

[This message has been edited by unboundmo (edited 09-08-2009).]

How big is the fiero decal?? I might buy one

I'll take the headlight. Send me your info please. Can you throw in the hinges as well???