Bump for lots of parts!

PM sent

How much for the jack? Also how much for the ocelot exhaust?

[This message has been edited by FTfiero (edited 01-24-2011).]

PM sent..

bump

Lots of parts left!
Please Inquire!

Hi... I'm looking for an '88 GT Front License Plate Bracket... complete with all screws etc.

I have PayPal... shipping to 91902.

Thanks much.
Greg

Bump
Please have a look through my inventory. I just may have what you need

Thanks
Matt

Do you have a v6 engine harness, manual transmission?

bump. Many more parts left for sale (or trade )

Matt

Bump. I am willing to TRADE parts for the following items:

I need:
-85-88 Interior Wiring Harness for V6 automatic
-Clutch Master cylinder sheet metal plug (on auto cars to block MC hole)
-TCC/Cruise brake switches
-87-88 4cylinder A/C Lines for swap

I need to get this swap done ASAP. Help would be appreciated.

Thanks
Matt

Do you have any good condition gray carpeting? How much shipped to 53086 if you have some?

Matt do you have an alternator for a 4cyl 84?

bump

I have added a few parts that came off of my 86GT V6.

86 2.8V6, 124,000 miles, runs great, comes with cradle, struts, all wiring, PCM and everything: $400 pickup only



Very nice factory exhaust system: $50 pickup only


Good Factory B-Pillar Performance sound speakers: $25 shipped


86 V6 4speed shifter and select cables: $25 apiece or both for $50 shipped



4speed shifter in good condition: $40 shipped


Request pics for items below:
86 V6 4speed Manual trans, 124,000 miles, needs new seals, $50 pickup only
Factory Air Intake, and Tube for V6: $30 shipped
Firewall PCV/EGR Solenoid Vacuum Tubes: $25 pickup Only
Undamaged Headliner Board: $30 pickup only
2 Grey GT Dashboards in good condition-$50
V6 EGR Tube: $40 shipped

[This message has been edited by mattman134 (edited 02-18-2011).]

Payment sent...and a bump!

------------------
~Stan
http://www.StanHinesleyPickups.com
-----------------------------------------------------------------------------------
"No, it's not an MR2!!!"

how much for the trunk release solenoid, the trunk release switch, and do you have the trunk release bezel? also

i did not see it but do you have the power door lock handle bezel/trim plate

thanks

shipping is to 27617

ALSO EDIT ----*************

In my local parts yard, there is a 87- gt automatic interior harness, i have looted the thing, so i could go pull the harness in about 10 minutes, it is complete, i just took the cross harness out for power options - if your interested in it, pm me for my phone number and we will talk, thanks again

mike

[This message has been edited by PF Flyer (edited 02-20-2011).]

Matt I found a couple parts I need:

wingnut off the 4 cyl air cleaner
Tube that goes from air cleaner to exhaust

The Joel Project is coming together!

ill sned yall the hose from intake to exhaust, ill shoot you a pm for adress

bump

Hi I am looking for a Cigerette Lighter Black Bezel with good mounting points. Mine has punched thru on the screw holes. Shipping is to 35957.
Thanks in advance.

------------------
Gary W. Patterson
Raven88
88 Fiero
86 Fiero GT

Matt,
You have a pm
~~Dan

Anybody heard from Matt?

[This message has been edited by shinesley (edited 03-05-2011).]

Bump

NEW items needed:

-Lower radiator support
-Driver side front brake hardline from Proportioning valve to brake hose/bracket

Matt, I received the Cigerette Lighter Bezel today, everything looks great.

Thanks for the fast service,

------------------
Gary W. Patterson
Raven88
88 Fiero
86 Fiero GT

Please LMK if anybody on here has a lower radiator support and a set of 87-88 4cylinder A/C hoses! (that bolt to the compressor)

Thanks
Matt

bump

I have a slew of newly listed parts for everyone to look at:
Also ***FREE*** items at the bottom of this post

85-88 V6 A/C hoses
84-86 4cylinder A/C Hoses


Factory headliner board


84-87 rear brake dust shields


Air Box/Water separator


85-88 V6 Exhaust System



Speaker Grilles (no covering)


Front Shocks (Brand Unknown)


Emergency Brake with Dark Gray boot


Front Crossmember Braces


Good 2003 3800SC Ignition Control Module



Free Items:
******FREE COME GET IT!!!!!!*****
I have a COMPLETE GT front suspension (Crossmember and all), good for rebuild
Also a somewhat complete front suspension from an 87SE, without the swaybar or steering rack.
87SE V6 cradle, comes with Control Arms, struts and a passenger side auto axle

I could scrap these items and make some money, but I absolutely DO NOT believe in scrapping Fiero parts, except unuseable items, such as a rusted out frame.

*****COME GET IT*****

Matt

Hey Matt what ya asking for these parts?

1 Set Grey Inner Door Panels with PM, PW, Door Pockets
1 Passenger Sailpanel
1 set Mirror Gaskets

Thanks,
Gary

bump

new parts listed

Looking for a good nose emblem for an 88 coupe.

Steve

Need full set of valve cover bolts for V6, 12. Bolt with attached washer.

Thanks

I need the sunroof storage support bracket (HVAC mechanical cover) and the 2 sunroof rubber support brackets that go under the front hood. Also the auxilary gauge bracket/housing shipped to 68601. PM me with price. Thanks

I have added a lot of new parts to the list:

COMPLETE V6 PARTOUT

86 2.8L V6, 124,000 miles, runs well, longblock (comes with water pump, intake, injectors, Throttle body and sensors: $50 come get it.


New V6 EGR tube, with hardware and gaskets. One gasket has a restrictor on it, to prevent engine bog


V6 manifold and y-pipe set, comes with heat shields. Manifolds and Y-pipe are in PERFECT CONDITION, no cracks.
Comes with new O2 sensor and EGR vlave: $50 plus shipping



Good V6 EGR solenoid: $15 plus shipping


New Delco-Remy Reman V6 alternator: $25 plus shipping, $40 with bracket



V6 Alternator bracket: $20 plus shipping, can also be included with alternator


V6 A/C compressor (DA-6): $30 plus shipping, $50 with brackets


V6 A/C Compressor brackets: $15 plus shipping, also can be included with compressor


V6 Thermostat Housing: $20 plus shipping


V6 Dogbone bracket: $15 plus shipping, can also include dogbone with poly bushings for a total of $30 plus shipping


2 MAP sensors, $15 plus shipping each


Good V6 Oil pressure sending unit: $15 plus shipping


Good Delco V6 starter: $30 plus shipping


Set of V6 ignition wires, OEM replacement, Very good condition: $20 plus shipping


V6 Coolant tube, Tstat Housing to LH coolant pipe: $15 come get it


*****3800 items*****

ICM, Crank, Cam ignition subharness: $20 plus shipping


W-body L36, L67 Oil filter housing. Same as $99 WCF kit: $25 plus shipping

[This message has been edited by mattman134 (edited 04-30-2011).]

pm sent

bump

bump. lots of good deals and steals left

Matt

how much for the whole bus?
.
jk!

bump

My fiero parts hoard is taking up lots of space