I have added a few parts that came off of my 86GT V6.

*****EDIT*****
Lowered prices for a quick sale:

I have added a lot of new parts to the list:

COMPLETE V6 PARTOUT

V6 manifold and y-pipe set, comes with heat shields. Manifolds and Y-pipe are in PERFECT CONDITION, no cracks.
Comes with new O2 sensor and EGR valve: $50 plus shipping



Good V6 EGR solenoid: $15 plus shipping


New Delco-Remy Reman V6 alternator: $25 plus shipping, $40 with bracket



V6 Alternator bracket: $20 plus shipping, can also be included with alternator


V6 A/C compressor (DA-6): $30 plus shipping, $40 with brackets


V6 Thermostat Housing: $20 plus shipping


2 MAP sensors, $15 plus shipping each


Good V6 Oil pressure sending unit: $15 plus shipping


Good Delco V6 starter: $25 plus shipping


V6 Coolant tube, Tstat Housing to LH coolant pipe: $15 come get it


*****3800 items*****

ICM, Crank, Cam ignition subharness: $20 plus shipping


W-body L36, L67 Oil filter housing. Same as $99 WCF kit: $25 plus shipping



84-87 steering knuckles with spindle nuts: $25 shipped


84-87 Emergency Brake Cable, Set (Only front is pictured.) Great condition: $20 apiece, $60 for the set of three shipped



Request pics for items below:
Factory Air Intake, and Tube for V6: $25 shipped
2 Grey GT Dashboards in good condition: $50

[This message has been edited by mattman134 (edited 01-26-2012).]

I would offer $25 shipped for the brackets that bolt to the 4 speed tranny (where the shift select cables connect)

bump. I would be willing to make some VERY generous trades for this list of parts I need for the swap:

Does ANYONE happen to have ANY of the following for my swap?

-85-88 Interior Wiring Harness for V6 automatic
-86-88 GT rear harness with cruise
-Clutch Master cylinder sheet metal plug (on auto cars to block MC hole)
-TCC/Cruise brake switches
-87-88 4cylinder A/C Lines for swap

Thanks
Matt

the car i mentiond in the other thread also has the 87 gt rear harness with cruise control, labor for that would be involved since the engine bay is untouched,

once again shoot me a pm, and we will talk

thanks mike

More parts to add:

84-87 steering knuckles with spindle nuts: $25 shipped

84-87 Emergency Brake Cable, Set (Only front is pictured.) Great condition: $20 apiece, $60 for the set of three shipped

Dogbone with poly bushings installed: $20 shipped


Matt

I have a few more items to list from my swap:

99 Grand Am Brake caliper slider bolts and bushings: $20 shipped

85-88 V6 EGR tube, perfect condition, comes with gaskets and mounting hardware: $40 shipped


Thanks
Matt

bump

All items shipped except for FIero GS's 4spd shift bracket, and GT40 Kit 3.8 SC's clutch pedal and MC rod

Matt

bump

I have a slew of newly listed parts for everyone to look at:
Also ***FREE*** items at the bottom of this post

85-88 V6 A/C hoses
84-86 4cylinder A/C Hoses


Factory headliner board


84-87 rear brake dust shields


Air Box/Water separator


85-88 V6 Exhaust System



Speaker Grilles (no covering)


Front Shocks (Brand Unknown)


Emergency Brake with Dark Gray boot


Front Crossmember Braces


Good 2003 3800SC Ignition Control Module



Free Items:
******FREE COME GET IT!!!!!!*****
I have a COMPLETE GT front suspension (Crossmember and all), good for rebuild
Also a somewhat complete front suspension from an 87SE, without the swaybar or steering rack.
87SE V6 cradle, comes with Control Arms, struts and a passenger side auto axle

I could scrap these items and make some money, but I absolutely DO NOT believe in scrapping Fiero parts, except unuseable items, such as a rusted out frame.

*****COME GET IT*****

Matt

I'd probably take that stock exhaust along with the one I gave you once we get this 3800 exhaust thing rolling.

bump

new parts listed

list of new parts added and priced for quick sale!

bump

low price bump

parts still for sale

pm sent.

bump

My fiero parts hoard is taking up lots of space

hay dave just got my pff name yaaa

bump-erpad

pm sent

parts still for sale. I need to pay for new paint, so I am selling at reduced prices

There is a black plastic(?) hose coming out of the valve cover on the same side as ,and above , the starter. It is part of the emissions. I need this part. It ends underneath the throttle body. Shipped to me at 77364. I do have a PayPal account.

Thanks
-Joe Crawford

[This message has been edited by josef644 (edited 05-16-2011).]

PayPal info requested

Entire dropout was scrapped.

Items left over:

have the following left:

Perfect set of V6 vacuum lines
Distributor
Coil
Tach Filter
Oil Dipstick
Oil pressure sender tube
Oil pressure sender
All Accessories and Brackets (Alternator, Water Pump, A/C Compressor)
Fuel Hardlines
Injectors/Fuel Rail and Harness
Others

Do you still have the dogbone? Will this for my 87 GT? Also do you have the hardware to mount the dogbone bracket to the engine? Thanks, Josh.

bump

bump

PP sent for Emergency Brake with Dark Gray boot

Pm sent

Matt, just the two exhaust mainfold heat shields, shipped to 77364. Don't need the rest.
-Joe

Lots of parts left and Summer is here

PM Sent!

2nd PM sent for additional parts.

[This message has been edited by 86GTFastback (edited 07-05-2011).]

bump

How much would you want for the 3800 ICM?

bump

bump

If the two exhaust manifolds are still available, how much for them shipped to 37660?

Jonathan

Nice

bump