Please close in the front radiator hole, lower fog lights and put the transam fog lights on one picture but reduced in size so they look propotional and approximate same location as the TA. Then outside lights and fogs on another. Thanks I figured out how to add stuff but not to properly fill.
[This message has been edited by LornesGT (edited 01-21-2015).]
Please close in the front radiator hole, lower fog lights and put the transam fog lights on one picture but reduced in size so they look propotional and approximate same location as the TA. Then outside lights and fogs on another. Thanks I figured out how to add stuff but not to properly fill.
Close again! Leave the original foglights covered over that are on the Fiero and put the blinker and air dam holes underneath the blinkers that are on the trans am in the same postion as the trans am but on the fiero.
Close again! Leave the original foglights covered over that are on the Fiero and put the blinker and air dam holes underneath the blinkers that are on the trans am in the same postion as the trans am but on the fiero.
I know it's not quite there yet but had to share thought it looked pretty cool
I hope so because I will be closing mine in very close to this. The Trans Am and Corvette have gotten away with if forever haven't they?
I don't know maybe ? some duct work behind the vents to bring it to the radiator and a strip across the bottom like the trans-am has to bring the air up to it might help?
I don't know what I did different this time versus last time when I colored the PS you did for me but this time the extension on the file is xcf and I can't post it. I just tried to alter another and save as jpeg but I done have the option.
[This message has been edited by LornesGT (edited 01-24-2015).]
I know what your thinking just buy a trans am. As much as I have viewed pictures of the WS6 I wish I could. Maybe when I complete my Fiero I will. I have a line on a damaged bumper, I hope the prevouisly PS parts are proportioned closely so I can match them up and bond them. Also I am pretty sure the materials are different. The guy (I assume) I am texting about the bumper ( I sent a link too this page) said it needs ram air so I added it and I actually like it.
[This message has been edited by LornesGT (edited 01-30-2015).]
Good times! find a picture of a Pegasus and do a cut and paste like you have been doing and lay it over the top to size it up to the bird then right click copy on it. then control Z until it goes away so you can remove the bird where it may have been sticking out from behind it. when thats done right click paste and put it where you want it
I can't find a white TA with those air vent to make it easier to colorize.
Go to saturation click on the color you want to go away or leave it on master and play with hue and saturation for awhile and after you get the color right you can do brightness and contrast to get it even closer to looking less photo chopped
I know it's not quite what you asked I can make it into a fast back but it was this angle that fit the IMSA better
Nice makes me want one of these also! Any good instructional videos on how to. I would like to able to take that dark picture that you manipulated to the body moded picture you just did. Excellent job!!!
Nice makes me want one of these also! Any good instructional videos on how to. I would like to able to take that dark picture that you manipulated to the body moded picture you just did. Excellent job!!!
I kind of lucked out on that I selected that area and thought I would take some contrast out of it first so it did not have so much reflection. as I was doing that it lightened it up and grayed it out right where it needed to be. I said sweet ! Keep playing with the colors until you find the desired effect you want. if you do not like it do a control-z to bring it back to what it was before and try again
.jpg)
.jpg)
_1.jpg)
_1.jpg)
