After reinstalling my windshield cowling, I noticed an outward bowing on the passenger side – I guess from bending during removal. Is there anything that will get it to lay flat into place again besides removing and reshaping it?....





Also after reinstalling the passenger side pillar, only at that time I ever really noticed the big gap between the weatherstrip and the pillar itself. Did I reinstall it wrong? I believe I have the other end in place but this end just doesn't want to budge and doesn't look right....




Thank you all

[This message has been edited by Brent7088 (edited 08-20-2019).]

I would first try a hair dryer on it while it is on the car. Sometimes it just needs a little memory jogging.

The A pillar trim is supposed to lock over/around the lower door trim piece at the front.
It looks to me, from your photo, that the A pillar trim needs to come up a bit, the top sliding a little father back into the B pillar trim.