I have been searching all over and I would like to know if anyone has the measurements of the rear subframe or even better CAD drawings of it on pre-88 Fieros. I have an 84 SE that I am about to start a serious project on and this information would be very helpful. It seems only the 88's get special CAD treatment, and every post I have found asking about anything pre-88 just points to the FSM and the bolt locations which is not helpful. For inquiring minds I will post what I need to replace my iron duke with.

I don't have specifics, but I hope someone can help.

Here's a couple of related threads. Maybe one of these guys can help
http://www.ns355.ca/engine-cradle.html
https://www.fiero.nl/forum/A...110502-2-099602.html

------------------
'87 GT , '00 3800 Series II SC, 4t65e, Vue Power Steering. (SOLD)

Those do help a little, thank you

The dimensioned drawings are from the FSM. I have never seen dimension data on the control arm pivots.

quote Originally posted by vortec87: I have been searching all over and I would like to know if anyone has the measurements of the rear subframe or even better CAD drawings of it on pre-88 Fieros. I have an 84 SE that I am about to start a serious project on and this information would be very helpful. It seems only the 88's get special CAD treatment, and every post I have found asking about anything pre-88 just points to the FSM and the bolt locations which is not helpful. For inquiring minds I will post what I need to replace my iron duke with.

Wow! Are you going to create a build thread? I definitely want to keep up with this build! If not, I will subscribe here and hope for updates.

Hopefully, I will have a build thread started in a few weeks. Parts have been slow to show due to COVID.

quote Originally posted by vortec87: Hopefully, I will have a build thread started in a few weeks. Parts have been slow to show due to COVID.

Can't wait to see this thread!!

Dime