Amid, are there any plans on breaking out your molds for your latest front bumper? I was hoping you might consider producing another when it gets warmer weather , I would really like to have one.
------------------
87GTseries 1 3800sc (7.597 @88.53 1.579 60ft) (series II swap in progress) 85GT Northstar/ 4t80e Northstar Rebuild
Amid, are there any plans on breaking out your molds for your latest front bumper? I was hoping you might consider producing another when it gets warmer weather , I would really like to have one.
Test panel stripped of vinyl and recovered in leather. Unlike vinyl, leather does not stretch very well making application more challenging & time consuming, but it can be done. The thinner & softer the leather is the better it is to apply.
Woo-hoo can't wait to see more of this leathers doors panels. .... my dreams almost come true through your creations Rob . Thank you for your talent !!!!!
Woo-hoo can't wait to see more of this leathers doors panels. .... my dreams almost come true through your creations Rob . Thank you for your talent !!!!!
Insert panel installed with optional diamond stitching using a piece of scrap leather leftover from an earlier job. Will cover the pocket panel next with another piece of scrap leather. Thanks.
[This message has been edited by Amida (edited 06-15-2016).]
G1 test panel installed with black/dark grey leather. I can really smell that leather. The light grey pull handle is all I have on hand. The white dot marks the location of the manual window crank shaft.
[This message has been edited by Amida (edited 06-18-2016).]
Beautiful! Please keep making these for a few more months. I'm in the middle of buying a house right now, but as soon as the financial dust has settled from that, I plan to hit you up for an estiamte.
Beautiful! Please keep making these for a few more months. I'm in the middle of buying a house right now, but as soon as the financial dust has settled from that, I plan to hit you up for an estiamte.
Black C3 Corvette handles test fitting. These are from Mid-America. I have discovered that handles from different makers require different amounts of spacing. Top mount varies by 3mm, and the bottom mount varies by 4mm. Up to three 1/4" flat washers are added depending on which handles are received...very strange, I would think there would be better consistency.
[This message has been edited by Amida (edited 07-02-2016).]
