Got the sun roof tracks and the dew wipes in the mail. No complaints at all, was packaged perfectly, Richard included rivets needed for installation, great quality stuff. Thanks for being such a great help to the Fiero community!!! Highly recommend Richard if you need dew wipes or sunroof tracks.

Thanks,
Carputing

Is this still being done? How about a pricing recap?

Also some pictures seem to be down, I would be interested in the instruments/radio/4spd shifter/glovebox pocket bezels, I haven't seen any pictures of the glovebox pocket, and I would like to see how much the stainless protrudes upwards from the shifter bezel, and whether the edges are smoothed, or sharp (don't want to scratch my arm on it).

What finishes are you using, I would most like a brushed or matte finish that is similar in reflectivity to the stock plastic. How thick are these made? Especially for the shifter bezel, I don't want it to look and feel like I obviously glued a sheet of metal on the factory bezel, making it thicker/protrude more.

Are they made slightly larger then the factory bezels to protrude over the indented black border, or are they made only to the size of the silver part of the bezels?

I read something in this thread about wheel center caps, more info on those?

Also the rocker panel things, they only cover half the rocker panel, right? Or do they extend down from the original rocker?

Thanks, if you still do this, and I think the shifter bezel will work well, you can count on an order at the end of March (or at least the money to pay for it, if an order can be made up/in stock before then, to ship upon payment, that would be super great)!

Also did you do the keychains for the Fiero 40th? If so, I bought like 10 haha, have one on my keychain I use every day, it is winning a fight with the rubber coating on my Pontiac G5 key, and the Silver coating on my Fieros generic replacement keys!
From my (very imprecise) measurements, the keychain appears to be 18ga, like the gauge bezels, if the keychains and gauge clusters are the same thickness, I'll be able to use my keychain to "test fit" and see if the thickness is ok, but I'll still want to know whether the edges extend over the black border on the factory plastic, or whether they stop at the edge of the silver, leaving a gap.

[This message has been edited by 1985 Fiero GT (edited 03-14-2024).]

quote Originally posted by DLCLK87GT: is there anything on the back of these for mounting purposes like a stud or just flat?

I can put studs on the back. I have 4mm and 6mm available not sure what length I would use though.

Rich