I need a front wheel bearing cap/cover/dust cover that goes over the nut that has the cotter pin in it. My 86 1/2 gt is missing this part and I cannot seem to find one. Thanks in advance!

This??


From a low mile 86 I parted recently. I will PM you...

EDIT...PM sent

[This message has been edited by weloveour86se (edited 06-17-2013).]

You can get them from Help section at most auto parts stores.

quote Originally posted by fierocarparts: You can get them from Help section at most auto parts stores.

Really? Nice and clean and shiney too? Hmm I will have to go and grab some then as the ones on my 86 look like hell. TY for the heads up!! And here I was saving this part....Sigh.
------------------

[This message has been edited by weloveour86se (edited 06-17-2013).]

He is correct on the Help dust cover. It's actually a Dorman product. Clearance is a little tight on them . Make sure the cotter pin is bent over well and not sticking outward. Spin the rotor and listen to ensure there is no interference/scraping after you pound it back on.
Note, to keep from caving in/denting the cap simply use a hammer & flathead screwdriver, pounding round the caps ridge, ok?
Kit

[This message has been edited by Kitskaboodle (edited 06-18-2013).]

Yeah, I've been saving parts that I've since found you can buy new and local. Like washer fluid bottles. Was taking up a lot of room and you can get new for less than $15. And parking brake cables you can get for $7-$8 new.

I have 2 brand new ones if anyone is interested...

Does anyone know the Dorman part# for this bearing cap?

Is it this?