Ok.... LOTS of parts. Prices do not include shipping (I will charge what USPS - flat rate and per pound, or UPS charges me, including any boxes, sorry, I just don't have that many boxes on hand). I will combine multiple items in one shipping box where possible.
Decklid Springs (white), from notchback - $10 (I have a buyer)
NOS rounded mouldings behind doors - $30 (I have a buyer)
Decklid Springs (red), no rust, plain decklid, notchback - $10
Inspection cover, V6 - $5 (I have a buyer)
V6 aluminum bracket - $10
Heat Shield, Coil - $3
Misc V6 bracket - $3
Rounded Moulding, used, behind door - $5
Notchback engine vent side piece (L&R) - $5 -may have buyer
Rounded front marker lights - $20 (I have a buyer)
Hood release lever - $5
Grey seat belts - $20 (I have a buyer)
Tan radio surround - $20 may have buyer
V6 fuel lines - $5
V6 dog bone (bad rubber) - $5 may have buyer
V6 engine bracket - throttle - $3
V6 front exhaust heat shield - $10
Door hinges (ok as is, but should be rebuilt) - $20 (I have a buyer)
Seat recliner levers, NOS - $20 (I have a buyer)
Front turn housings - $5
Front turn housing, single - $3
Ashtray doors (need to be painted, but not cracked) - $10
Misc NOS parts - $5 (I have a buyer)
Spoiler gaskets - $5 (I have a buyer)
Power lock and bracket - $5 (I have a buyer)
V6 engine strut/shock - $10
V6 engine bracket - $3
Hood release lever #2 - $5
Oil cap and misc vent hose - $3
Gas fill cover - $5 (I have a buyer)
Gray visors, should be recovered, but otherwise good - $20 (may have a buyer)
Decklid hinges - $10 (I have a buyer)
Marker lights, front and rear - $20
Interior trim, grey, photo shows red tint, but that is only in photo - $5 - shipping would be high because of size
Headlight bezzle trim - $10
Misc door and other weatherstripping - $20 (I have a buyer)
[This message has been edited by jaskispyder (edited 11-13-2013).]
I'm interested in the Gas Tank Release Lever for $5.
Also wondering if the Steering Column would fit and work correctly in an '88 4-cyl Coupe - also any idea of shipping costs to 27610? I don't need the steering wheel.
Thanks!
------------------ Patrick W. Heinske -- LZeitgeist@aol.com
1988 Fiero Formula - Automoda convertible repainted PPG Ferrari 'Giallo Modena' yellow
Does the tach and oil pressure gauge work in the cluster?
Sorry, I have no way of telling at this time. I believe they both worked, but again, I can't promise anything sorry. BTW, I though the speedo was bad in this one, but I may be wrong about that (there was a speedo that was marked as bad in my pile and this one wasn't marked. I may have thrown that unit out.
Do you still have the HOOD RELEASE LEVER, whichever is better if you still have the 2, & I also could use a couple windshield washer squirters that the hose hooks up to, to squirt on the windshield!!!! They need the round tube the hose goes over !!!! Mel shipped to 60185
Do you still have the HOOD RELEASE LEVER, whichever is better if you still have the 2, & I also could use a couple windshield washer squirters that the hose hooks up to, to squirt on the windshield!!!! They need the round tube the hose goes over !!!! Mel shipped to 60185
Yup, I have the hood release lever. I don't have washer nozzles, sorry. Shipping would be less than $6. If that works, pm me your address and I will send it and you can send me the total via Paypal.
[This message has been edited by jaskispyder (edited 11-01-2013).]