So do you need all the coolant tube brackets or ones on either side? What I'll do is cut out a larger section than you need so you can trim it down to what you need.
So do you need all the coolant tube brackets or ones on either side? What I'll do is cut out a larger section than you need so you can trim it down to what you need.
i want the each side driver and passenger ( rear coolant brackets the one that have 2 hole ) i need the floor part welded with it like the pictures . i wanted bigger but im located far from you and it will cost me an arm and a leg to ship
it wouldn't be much bigger, maybe an inch on each side of the areas you need, just enough so you have some wiggle room.
depending on how big the control arm is and how much it weighs, should be able to keep shipping costs down to a few fingers and a couple of toes instead of the whole arm and leg.
[This message has been edited by 94blackbird (edited 07-06-2014).]
yes that would be nice if it has no big rust on it i will pay you i have paypal ready
Alright, I will let you know tomorrow evening. If everything is kosher should have it all cut out and ready to ship by the end of the week at the latest.
Alright, I will let you know tomorrow evening. If everything is kosher should have it all cut out and ready to ship by the end of the week at the latest.
nice i wait for your news if you can cut 1 inch more at each side that will be very appreciated and i wrote on the thread the explanation under the pic for the cut so you just need to add 1 inch at each side . thanks a lot . i wait for your news