Intake is SOLD.
.
.
.
.
.
.
.
.
Complete TPI fuel injection conversion designed for Chevrolet V8 Fiero utilizing Vortec center-bolt heads. This is an original V8 Archie-swapped TPI system off of a low-milage 350, complete with HEI distributor, computer and pre-wired harness.
Conversion includes:
*Scoggin-Dickey lower intake manifold
*TPIS EGR and cold start injector block-off plates
*Accel 24lb fuel injectors
*GM fuel injector rails
*GM upper intake plenum
*GM throttle body with Archie throttle linkage
*GM upper intake runners
*GM HEI distributor with Accel high performance ignition module
*Pro-Form 50,000 volt ignition coil
*Holley throttle body air-foil
*Complete engine harness with computer
*Street & Performance custom burned chip
*Pre-labeled connections for easy installation
This system is complete, minus sensors (which you will want new anyways). All you need is a SBC with modern Vortec center-bolt heads for this conversion to work.
More pictures and information available upon request.
Asking $600 shipped, OBO.
[This message has been edited by ITALGT (edited 03-06-2016).]
