We had a small batch (100 minimum order) of P-seals re-produced. Now that I have my customers orders fulfilled, I can now make the rest of the inventory available. These may need to be riveted along the seal. Do to a lower cost per piece, we are able to offer these at a lower price. The cost is 100.00 per seal 15.50 flat rate shipping in the U.S. up to 2 P- seals.
parts@fieroparts.com is for emails Tim@fieroparts.com for PayPal payments
Tim
[This message has been edited by fieroparts.com (edited 04-02-2018).]
If you know anyone with a T-Top, and they do not know of this sale, then now is probably a good time to direct them along. This kind of an offer does not happen often, and could even be considered rare I feel. Hence my reasoning for commenting. Even mildly worn seals will soon be majorly worn. Now is an opportunity.
Nice thread. This is not a product that you can just find off the shelf folks.
Here ya go! These seals run the width of the car and seal out dirt, grime & water from the channel under the glass when the glass is installed (also helps keep wind noise in check).
Any chance for a small run of weatherstrips for the t top:-)
We made 4 attempts, in 2001, 2002, 2003 and 2005. In 2001 we contacted the original manufacture, they would do it but the minimum order was 55K After just spending tens of thousands for all of the t-top parts, that was not going to happen! In 2002 and 2003 both vendors wanted a 100K+ order, ya, right. In 2005 we were found a small shop out west to make the seals for us, with a 25K order. When i posted to this site to see if there was any REAL interest, only one person was wiling to commit. The price was going to be 650.00 a set. Even if I wanted to make another attempt, I don't have a new set to work from.
Originally posted by fieroparts.com: We made 4 attempts, in 2001, 2002, 2003 and 2005. In 2001 we contacted the original manufacture, they would do it but the minimum order was 55K After just spending tens of thousands for all of the t-top parts, that was not going to happen! In 2002 and 2003 both vendors wanted a 100K+ order, ya, right. In 2005 we were found a small shop out west to make the seals for us, with a 25K order. When i posted to this site to see if there was any REAL interest, only one person was wiling to commit. The price was going to be 650.00 a set. Even if I wanted to make another attempt, I don't have a new set to work from.
10 more sold today, down to 21 left
Thank you for history on the weatherstrips. For what it's worth, 3D printers can now use rubber filliment. Not sure if something like the weatherstrips could be made lower cost and smaller qty
This kind of an offer does not happen often, and could even be considered rare I feel. Hence my reasoning for commenting. Even mildly worn seals will soon be majorly worn. Now is an opportunity.
This is not a product that you can just find off the shelf folks.
.jpg)
