Looking for the pig tail that goes from distributor to coil, and the other side that goes to the loom. I need both that connect to the top of the coil.

Pics can be provided if'n necessary.

Thanks in advance,

Tony

[This message has been edited by Tony Kania (edited 06-21-2019).]

Hey Tony, the Fiero store carries the coil to dizzy setup. I suggest it as most OE ones are brittle these days. Hope this helps.

I did not even think of that! Thank you so very much. New is better.

I sell them also

http://www.reddevilriver.com/2.html

I put the Red Devil one on my car. Nice piece. If you are local you can have my old one.

------------------
2001 Regal GS 180 Stat and K&N
1999 Camaro Z28 B4C Heads Cam Intake Stall etc
1992 Ford Mustang LX 5.0 331 R block S trim Intercooled
1988 MR2 SC Cammed,Pulley etc
1988 Corvette Cammed stalled bolt ons
1985 Fiero SE V6-Transgo,stall,K&N,cat EGR delete,Ported TB,Sprint headers

quote Originally posted by phonedawgz: I sell them also http://www.reddevilriver.com/2.html

Do you also sell this, or can you make one to go with your ICM connector? Rear side of coil to harness under intake...

If Timm doesn't have it, Rockauto does. At least it looks like it.
https://www.rockauto.com/en...+coil+connector,2592

[This message has been edited by Raydar (edited 06-27-2019).]

The Standard Motors parts numbers are TX3A (ICM side) S563 (coil).