Did you all install it without modifying the original sheet metal location? or did you end up making the sheet metal cutout larger to accommodate the larger light?
If you did cut the sheet metal, can you post pics of it?
Did you all install it without modifying the original sheet metal location? or did you end up making the sheet metal cutout larger to accommodate the larger light?
If you did cut the sheet metal, can you post pics of it?
Thank you in advance.
You need to cut the hole and make it larger. I don't know the measurements exactly, just cut it slowly until it fits. Pretty easy.
I sold a bunch of these years ago. If memory serves I used a file and shaved off the lower width of the opening. Don't over cut the opening or the carpet will keep pushing the light back out. I believe Dorman has a LED replacement bulb.
Spoon
------------------ "Kilgore Trout once wrote a short story which was a dialogue between two pieces of yeast. They were discussing the possible purposes of life as they ate sugar and suffocated in their own excrement. Because of their limited intelligence, they never came close to guessing that they were making champagne." - Kurt Vonnegut
